Trigger Settings

Important

On this page, perform settings in the order: Start Setup -> Function Setting Barcode -> End Setup.

Scan Mode

Level Trigger

Scanning starts while the scan key is held down and ends after a successful decode or when the read timeout is reached.

* Level Trigger

Auto Sensing

Scanning starts when image changes are detected and ends when the read timeout is reached.

Auto Sensing

Continuous Scanning

Continuously read one or multiple barcodes. The same-code interval setting defines the decode order. Press and release the scan key to start or stop scanning.

Continuous Scanning

Same Barcode Read Mode

In auto sensing, continuous scanning, and pulse trigger modes, you can configure how repeated reads of the same barcode are handled.

Note

By default, the same barcode is not read again within 500 ms. The interval can be set to 0~5000 ms, where 0 means no interval.

Suppress Repeated Reads

If the same barcode is read repeatedly within the suppression period, it is ignored and not output, and the timer restarts.

Interval Read

If the same barcode is read repeatedly within the interval, it is ignored and not output. It is output again after the interval expires.

Do Not Repeat Same Barcode

The same barcode is not output repeatedly.

Example: Suppress repeated reads of the same barcode within 100 ms.

1. Scan “Start Setup”.

2. Scan the “Suppress Repeated Reads” setting barcode.

3. Scan the “Read Interval” setting barcode.

4. Scan the 1 setting barcode in Decimal Digits.

5. Scan the 0 setting barcode in Decimal Digits.

6. Scan the 0 setting barcode in Decimal Digits.

7. Scan “End Setup”.

Example: Read the same barcode again after a 1-second interval.

1. Scan “Start Setup”.

2. Scan the “Interval Read” setting barcode.

3. Scan the “Read Interval” setting barcode.

4. Scan the 1 setting barcode in Decimal Digits.

5. Scan the 0 setting barcode in Decimal Digits.

6. Scan the 0 setting barcode in Decimal Digits.

7. Scan the 0 setting barcode in Decimal Digits.

8. Scan “End Setup”.

* Suppress Repeated Reads

Interval Read

Do Not Repeat Same Barcode

Read Interval (ms)

Decode Time

(This setting is not supported in continuous scanning mode.)

* 5 Seconds

10 Seconds

No Limit

Sleep Time

Disable

1 Second

2 Seconds

3 Seconds

5 Seconds

7 Seconds

* 10 Seconds

15 Seconds

Auto Sensing Sensitivity

Low Sensitivity

* Medium Sensitivity

High Sensitivity

Decode Data Verification

* Disable

Output After Reading Twice

Output After Reading Three Times